Products & Systems

	Solid Floor
	Suspended Floor
	Battened Floor
	Floating Floor
	UFH Pipe
	Manifolds
	UFH Control System
	One Room System
	The installation descriptions above are summaries only and should not be taken as full installation specifications. With all Underfloor Heating Systems, the pipe loops must be filled and under pressure during any floor laying process. During periods where there is a risk of freezing, special precautions must be taken.

Floating Floor

This system has been specifically developed for use with sheet flooring materials and engineered boards, with a laminate, or natural timber finish.

It is particularly easy and quick to install and being a totally dry system, can be commissioned immediately after installation.

As the system has low thermal mass, it responds well to changes from the temperature controls.

Installation

• The flooring insulation is laid on the oversite concrete (as supplied by you)
• Robbens 50mm routed HD flooring grade polystyrene insulation is laid on the flooring insulation
• Pipe clips are pushed into the slots leaving 50mm approx. between clips
• The pipes are pressed into the clips
• The Robbens Aluminium Heat Conducting Sheets are laid across the floor in rows
• A vapour barrier is laid over the Heat Conducting Sheets and the sheet flooring or engineered boards laid over
• 60°C flow temperature
• Low thermal mass system and therefore responds well to control changes
• 70 watts/sq.m maximum output