Adaptive manifolds are intended for use in projects where the supplied water temperature adjusts itself above and below the required temperatures for the underfloor heating.

In some cases, if an adaptive manifold is to be used, but the weather compensator needs to go higher for an additional heat emitter such as radiators, then the underfloor heating could overheat. By fitting a modulating manifold, it will operate like a traditional temperature controlled manifold all the time the water temperature is higher than required. However, if the water temperature was to drop lower than the underfloor heating’s requirement, then the modulating part of the manifold would shut off to prevent any additional blending and therefore optimising the usage of the supplied water temperature.

These manifolds are best used in situations where there are multiple floor types and there is a modulating water temperature. They may also be useful in situations where a heat pump is to be added to the project in the future.

Our service:

• Bridges the gap between current and distribution manifolds
• Allows over temperature protection
• Stops additional blending if the water temperature drops
• Designed using traditional techniques and made with modern components
• Easy to fill, pressure test and drain
• Components can easily be obtained for future servicing needs
• High quality individual parts hand assembled to an extremely high standard
• Fully assembled and delivered to site ready for installation
• Pre fixed to a mounting board
• Pre balanced for easy commissioning
• Pre labelled for easy connection during installation
• All actuators and pipe fittings supplied
• Modulating water temperature control unit fitted
• 3 year guarantee